The robot top LEDs do not turn green when positioned on the yellow marks
If the robot's top LEDs stay yellow on the yellow corner marks, work through these steps in order. They are listed from the most to the least common cause.
- Reduce the light. The robot uses light sensors to find its position, so direct sunlight, a bright window or strong overhead light can stop it from turning green. If the LEDs turn green while your hand shades the robot and go back to yellow when you move your hand away, the light is too strong. Close the blinds, move away from the window or dim the room. You can also use the board to shade the robot.
- Adjust the position. The yellow mark is only about 1–2 mm larger than the robot, so nudge the robot gently until it sits exactly inside the mark.
- Check the battery. If the robot's top LEDs blink red, the battery is too low for an accurate reading. Charge the robot with a USB-C cable for at least an hour, then try again.
- Try another corner. Any of the four corners should work.
- Mount the board and check again. If the LEDs still don't turn green, mount the board on the robotic base and check whether they turn green with the board in place.
- Use the in-app help. Tap "Having troubles?" at the bottom of the onboarding screen for a guided version of these steps.
Make sure the robotic base sits on a flat, solid surface, so it doesn't bend. If the LEDs still don't turn green, contact support.

